Manufacturing wires

Feb 10, 2021

Leave a message

First, start with copper slag. It doesn't have to be pure copper, anything, as long as it contains copper.


Because it is not the copper component, it will melt in the copper water and burn completely. To reach the boiling temperature of copper water, factory workers pump ultra-high pressure oxygen into the boiler.


The molten copper water (containing some impurities) flows into the mold. The mold is then immersed in water and cooled to a workable temperature.


After cooling, the molding die is sent to a giant electrolytic bath to remove impurities. The finished product is these much cleaner copper plates.


To make wires, the copper plates will be sent to the new workshop and melted again. The molten pure copper water is cooled and drawn into thicker copper bars. After being stretched, the thicker copper strip becomes a wire of the required thickness.

Send Inquiry